Shark Werks 997.2 Turbo / S Exhaust
Product Type: Exhaust
Application: 2010+ 997 Turbo / Turbo S DFI
At this time we are out of stock on this item, and expect to have more ready approximately 4/30/18
Made entirely of T304 0.065 stainless steel, mandrel bent to fit to the factory catalytic converters, our system not only unleashes a more sporty sound (you can hear those turbos spool) but it does so without drone or resonance inside the vehicle. You can continue to enjoy your Blue-Tooth phone conversations or PCM 3.0 iPod tunes without interference from the exhaust. Meanwhile, your 997.2 TT / S produces a deeper, throatier growl from the engine at the press of the gas pedal.
Our straight-through design improves upon the factory stock center muffler, which has no separation of exhaust gas pulses (as you can see from the hot spot in the middle of your factory unit if you examine it from outside). Our approach was to take the path of least resistance; to improve flow and reduce back pressure (all important for spool and power on a turbo car) by separating each of the banks with one exit for each side versus a more restrictive merge.
By retaining the factory cats, there are no check engine lights and the use of our exhaust should not affect the factory warranty or affect emissions equipment (therefore 50 state legal). Designed to work with factory or factory-style after market tips, installation is made easy by re-using the factory clamps and locations.
More exotic tone under boost
More aggressive sound at idle and audible turbo spool
Deeper/Throatier exhaust note
No interior drone/resonance @ freeway speeds
Improved flow & reduced back pressure for quicker turbo spool
Works with factory catalytic converters & emissions equipment
50 state emissions compliant
Made in California, USA
Smoother mandrel bent single piece tubes rather than welded sub sections for optimal flow
Re-uses factory clamps
Mounts to factory brackets/locations
Re-uses factory exhaust tips (or aftermarket)
Full DIY (do it yourself) step by step instructions provided
8 pound weight saving (19.2 pounds stock vs. 11.2 pounds)
Rear bracket mount attaches to OEM center muffler bracket using included stainless steel
fastener plates, washers and locking nuts.
Factory center muffler (top) compared to Shark Werks exhaust (bottom).
You may also be interested in:
You can see this product installed on cars in our project gallery:
Some of the products listed on this site are intended for off-road use only. Please read our important notice and disclaimer.