Shark WerksExhaust for 997 GT2 and GT2RS

Product type: Exhaust
Application:
  • 911 GT2 RS - 997.2
  • 911 GT2 - 997
Views
price$1995
Optional Coating
  • - Select -
View cart

Product Description

The 2008 997 GT2 and 2011 997 GT2RS, with its 3.6L GT1-based engine produces plenty of power, however some believe it could use a kick in the pants as far as the exhaust note. Exotic it is not. In stock form, it is extremely quiet and vacuum-cleaner-like. This is where your friends at Shark Werks come in with our replacement exhaust system (only for GT2 / GT2RS models).

Video Demonstration on 2011 GT2RS:

Made entirely of T304 0.065 stainless steel, mandrel bent to fit to the factory catalytic converters, our system not only unleashes a more sporty sound (you can hear those turbos spool) but it does so with minimal additional noise inside the vehicle. You can continue to enjoy your phone conversations or tunes without interference from the exhaust. Meanwhile, your 997 GT2 or GT2RS produces a deeper, throatier growl from the engine at the press of the gas pedal.

Our straight-through design improves upon the factory titanium stock center muffler, which has no separation of exhaust gas pulses (as you can see from the hot spot in the middle of your factory unit if you examine it from outside). Our approach was to take the path of least resistance; to improve flow and reduce back pressure (all important for spool and power on a turbo car) by separating each of the banks with one exit for each side versus a more restrictive merge.

By retaining the factory cats, there are no check engine lights and the use of our exhaust should not affect the factory warranty or affect emissions equipment (therefore 50 state legal). Designed to work with factory exhaust tips, installation is made easy by re-using the factory clamps and locations.

Features:

  • More exotic tone under boost
  • More aggressive sound at idle and audible turbo spool
  • Deeper/Throatier exhaust note
  • Minimal additional interior noise @ freeway speeds
  • Improved flow & reduced back pressure for quicker turbo spool
  • Works with factory catalytic converters & emissions equipment
  • 50 state emissions compliant
  • Made in California, USA 
  • Smoother mandrel bent single piece tubes rather than welded sub sections for optimal flow
  • Re-uses factory clamps
  • Mounts to factory brackets/locations
  • Re-uses factory exhaust tips
  • Full DIY (do it yourself) step by step instructions provided
  • Saves 1 pound over OEM titanium muffler at rear of vehicle

 

Rear bracket mount attaches to OEM center muffler bracket using included stainless steel
fastener plates, washers and locking nuts.

 

    You can see this product installed on cars in our project gallery: